Wipers

Style ST-XL wipers are molded from premium urethane and are direct replacements for Style “ST” or “D” wipers. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.

94A Durometer | Urethane Material | 8 in Nominal Inner Diameter

Features

• Crush lip to provide extra interference
• Bead on the shoulder to keep contaminants out
• Ribbed ID to prevent pressure traps

STXE wipers are designed to retrofit the standard ST wiper groove while providing superior performance. The o-ring energizer limits dirt intrusion around the OD of the wiper. The energizer also makes this wiper more effective in applications with severe side deflections.

Urethane Material | 2 1/2 in Nominal Inner Diameter

Features

• Designed to retrofit the standard ST wiper groove
• O-ring energizer limits dirt intrusion around the OD of the wiper

Suffix “V” designates fluorocarbon material,“N” designates nitrile material, and “HT” designates high temperature urethane.

90A Durometer | Urethane Material | 1 1/2 in Nominal Inner Diameter

Features

• Urethane Wiper Ring
• Min. Temperature Range of ‘-40 °F; N: -40°; V: -20 °F; HT: -40 °F
• Max. Temperature Range of 200 °F; N: 225 °F; V: 350 °F; HT: 225 °F

Suffix “V” designates fluorocarbon material,“N” designates nitrile material, and “HT” designates high temperature urethane.

90A Durometer | Urethane Material | 3 in Nominal Inner Diameter

Features

• Urethane Wiper Ring
• Min. Temperature Range of ‘-40 °F; N: -40°; V: -20 °F; HT: -40 °F
• Max. Temperature Range of 200 °F; N: 225 °F; V: 350 °F; HT: 225 °F

Utilizing a double lip of urethane bonded to a carbon steel case, this wiper prevents contaminant ingression at the wiping lip and around the outer case.

Urethane Material | 40 MM Nominal Inner Diameter | Wiper

Rubber Material | 1 7/8 in Nominal Inner Diameter | Wiper

Rubber Material | 1 7/8 in Nominal Inner Diameter | Wiper

Rubber Material | 2 in Nominal Inner Diameter | Wiper

Rubber Material | 2 in Nominal Inner Diameter | Wiper

This wiper is a single lip design molded from high grade nitrile and bonded to a carbon steel case.

Nitrile Material | 45 MM Nominal Inner Diameter | Wiper

Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.

90A Durometer | Urethane Material | 2 in Nominal Inner Diameter

Features

• Slotted heel design
• Slots in the heel allow excess hydraulic fluid to bypass the wiper

AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems.

AN wipers will retrofit into glands prescribed in MS-33675 for corresponding dash numbers of MS-28776.

• Flexible, snap-in design for easy installation into closed housings
• Low compression set