Rod Seals
Search in Category
Filter Your Search
Material
Nominal Inner Diameter
Nominal Outer Diameter
Style
Unit of Measure
Shop by Category
With redundant nitrile lips and an acetal back-up, this seal features high sealability and extrusion resistance.
NBR Seal; Acetal Or Fabric Reinforced Rubber Material | 90 MM Nominal Inner Diameter | Rod Seal
With redundant nitrile lips and an acetal back-up, this seal features high sealability and extrusion resistance.
NBR Seal; Acetal Or Fabric Reinforced Rubber Material | 95 MM Nominal Inner Diameter | Rod Seal
The MPDS is a rubber seal with a fabric-reinforced dynamic surface providing low breakaway and low dynamic friction. An acetal back-up ring is incorporated into the heel to prevent extrusion.
NBR/Neo-Fab Material | 50 MM Nominal Inner Diameter | Rod U-Seal
The MPDS is a rubber seal with a fabric-reinforced dynamic surface providing low breakaway and low dynamic friction. An acetal back-up ring is incorporated into the heel to prevent extrusion.
NBR/Neo-Fab Material | 90 MM Nominal Inner Diameter | Rod U-Seal
MK51 is a polyurethane pneumatic combo seal that is used as both a rod seal and wiper.
92A Durometer | Polyurethane Material | 12 MM Inner Diameter | Wiper
MK51 is a polyurethane pneumatic combo seal that is used as both a rod seal and wiper.
92A Durometer | Polyurethane Material | 16 MM Inner Diameter | Wiper
These seals are specifically designed with a second lip on their inside diameter and engineered to attain maximum, life and reliability in dynamic rod sealing. This feature results in reduced leakage, less friction, increased stability, and, prevents air and contaminants from entering the cylinder.
92A Durometer | Urethane Material | 5/8 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
Features
- General purpose rod seal
- Robust design
- Excellent wear resistance
- Increase seal stability
- Performs well over wide temperature range and is extremely effective in low temperatures
- Primary lip protection
- Easy to install
Style DRTU-BHT rod seals are molded in Freudenberg® AU 30000 urethane. These seals are specifically designed, with a second lip on their inside diameter and engineered to attain maximum life and reliability in dynamic rod sealing., This feature results in reduced leakage, less friction, increased stability, and prevents air and contaminants from, entering the cylinder. This high tear-resistant urethane demonstrates stability throughout a wide range of temperatures., In addition, this material is well suited to mineral and biodegradable hydraulic fluids as well as being resistant to, hydrolysis.
94A Durometer | Urethane Material | 1 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
