Search Results

Molded in urethane, this wiper is flexible enough to easily snap into a groove yet tough enough to handle difficult rod wiping applications.

Urethane Material | 32 MM Inner Diameter | Wiper

UPS – RED RATE

Hytrel backup ring with a flat cross-section.

Molded of 55D Durometer Hytrel, these back-up rings provide excellent extrusion resistance and tolerance to fluids such as phosphate esters, hydraulic oil and water. Stretched for installation, they return quickly to their original size for easy installation.

55D Durometer | Hytrel Material | 2 5/8 in Nominal Inner Diameter | 3/16 in Cross Section | Backup Ring

Features

• Improved extrusion resistance compared to standard FKM or NBR backups
• Can be stretched over larger diameters and will return quickly to their original size
• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation

2.75 in induction hardened chrome shafting.

The base material is 1045/1050 Carbon Steel with 0.0005 in (0.0127mm minimum)-thick chrome plating and a case depth of 0.05 in (1.27 mm).

Induction Hardened Chrome is typically used in abrasive envrionments where the cylinder is exposed to rocks or heavy debris. Also used to machine clevis pins.

• Greater strength
• Better resistance to mechanical damage

Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.

GB-PHEN-1×1/8-C/S TURQUOISE

Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.

Urethane Material | 25 MM Nominal Inner Diameter | Rod U-Seal

Features

• Excellent low temperature performance
• Easy installation

MHT-65X3000 has a wall thickness of 5.6 mm. The ID is 65 mm and the OD is 76.2 mm. The material is 1026 Carbon Steel and has been stress-relieved and annealed.

Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 3 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency

Molded in PTFE with a rubber energizer, this seal absorbs the shock of pressure spikes to protect the rod seal.

70A Durometer | Filled PTFE Buffer Material | 90 MM Nominal Inner Diameter | Buffer Seal

Utilizing a sturdy metal case, these wipers are molded from the same high performance urethane used in our Heavy Duty U-seals. Built for severe service, these wipers are capable of surviving hostile environments.

92A Durometer | Urethane Material | 1 1/4 in Nominal Inner Diameter

Features

• Used in Heavy Duty U-seals
• Capable of surviving hostile environments
• Molded from the high performance urethane